Hesperia Expert Fencing logo
A new tan slump-stone block wall with capped pilasters and black wrought-iron panels in front of a single-story stucco home, Joshua trees in the desert yard

Fencing in Hesperia, CA

Chain Link Fence Installation in Hesperia, CA

  • Typical cost: most 6-foot chain link fences run $13 to $30 or more a linear foot installed in national guides; a 4-foot fence runs $10 to $20
  • Timeline: crews install about 80 to 150 feet a day, and most jobs take 2 days or more
  • Wire gauge: residential fences mostly use 9- to 12-gauge wire, commercial ones 6- to 9-gauge
  • Before digging: state law requires notice to the 811 center at least 2 working days and no more than 14 calendar days ahead

Hesperia Expert Fencing hands your request to a chain link installer nearby for galvanized or vinyl-coated fence, walk and drive gates, or a taller perimeter run. A chain link fence is galvanized steel mesh stretched between steel posts, with a top rail, a bottom tension wire and fittings that tie it together, so wire gauge, post spacing and the footings decide how it holds up.

Get a free fencing estimate

Free for homeowners. One local contractor contacts you.

Gloved hands holding a level against a galvanized steel fence post set in fresh concrete, with a string line and more posts behind

Why Hesperia homeowners call Hesperia Expert Fencing

  • Calling or using the form doesn't cost you anything
  • We send your job to one contractor, so your phone isn't ringing all week
  • Ask for posts, footings, gates and haul-away priced line by line
  • Look up the C-13 (fence) or C-29 (block wall) license at cslb.ca.gov

Get a free fencing estimate

Free for homeowners. One local contractor contacts you.

Installation Timeline and the 811 Call

  1. 1

    Outline the dig area

    California law requires the excavator to mark out where digging will happen before calling.
  2. 2

    Notify 811

    Notice must reach the regional center at least 2 working days, and no more than 14 calendar days, before digging starts. The service is free, and utilities mark their lines with paint or flags.
  3. 3

    Set posts

    Concrete footings give better long-term support than driven posts, especially for tall fences and windy sites. Allow 1 to 4 days for concrete to cure.
  4. 4

    Rails, tension wire and mesh

    The fabric is stretched and tied off. Crews cover roughly 80 to 150 feet a day.
  5. 5

    Gates

    Hung and adjusted so they latch cleanly, then a final check before the last payment.
A new galvanized chain link fence with a top rail around a sandy back yard
A black vinyl-coated chain link fence with black posts along a gravel yard
A galvanized chain link double drive gate beside a single walk gate
A tall heavy-gauge chain link perimeter fence along a large open lot

Frequently asked questions

How far ahead does someone have to call DigAlert before chain link posts go in?

At least two working days and no more than 14 calendar days before digging, under Government Code 4216.2. The area to be dug has to be outlined first. The request goes through 811, the free national before-you-dig number, and the utilities mark their lines with paint or flags. Ask the installer who places the call and keep the ticket number.

What gauge chain link makes sense for a Hesperia back yard?

For most homes, 9- to 11-gauge. HomeGuide says residential fences mostly use 9- to 12-gauge wire, with 11 gauge as the standard residential wire and 9 gauge as the heavier residential and commercial choice. A smaller number means thicker wire. 11.5 gauge is listed as temporary fencing, so check the gauge on any low quote.

Is vinyl-coated chain link worth the extra cost over galvanized?

It depends on how much the look matters. Vinyl-coated chain link runs about $30 to $60 a linear foot installed against $10 to $40 for galvanized, and HomeGuide credits the coating with better rust protection, a longer life and more colors. Custom colors carry a 10% to 20% premium. Galvanized is the economical choice.

Can a chain link fence in a Hesperia front yard have privacy slats?

It can, but slats change how the city treats it. As we read the Development Code, slatted chain link doesn't count as an ornamental fence, so it falls under a lower front-yard height limit unless the lot is large. The figures are on the [wrought iron page](/services/wrought-iron-fence/). Slats themselves run about $5 to $18 a linear foot.

Should a chain link driveway gate swing or roll?

It comes down to space. A swing gate needs room to open, and a rolling gate needs a clear run of fence beside it to slide back along. Double swing drive gates 8 to 12 feet wide cost $175 to $500 before installation, and rolling gates 12 to 20 feet wide $350 to $1,000 or more. HomeGuide notes a slide gate may be necessary depending on the gate's width and the space available.

Ready to get started in Hesperia?

Request a free estimate